Riger DB102 - Router Mode
Go to http : //192 .168. 1.1
* Username: tmadmin
* Password: tmadmin
Then you will see this above page. Go and click at the WAN Tab and click at PPP.
Set the new interface as:
* PPP interface = 0
* ATM VC = aal5-0
* Protocol = PPoE
* Use DNS = enable
* Security = PAP
Don’t forget to set your username as USERNAME@streamyx and also your TMNet Streamyx password. When done, click Submit.
Click on ATM VC and make sure interface are set as:
* aal5-0 VPI = 0
* VCI = 35
* MUX = LLC
* Max proto = 2
After that, click on Admin and then Commit and then Reboot Once it’s done you should check your Internet connectivity by loading your favorite website.
If you’re unable to go to 192.168.1.1, please make sure that your PC IP is in the range of 192.168.1.x.
Done!
make sure your cabling is correct. from the modem to the router, connect through the WAN port. make sure both DHCP Server is enable on modem and router.
settings:-
modem (bridge mode, DHCP server enable, NAT disable)
router (router mode, PPPoE, DHCP server enable, NAT enable)
just browse the pages in both the modem and the router and find the things listed in the brackets. everything should work.

