markasandre
Freshie
- Messages
- 4
- Joined
- Jan 23, 2010
- Messages
- 4
- Reaction score
- 0
- Points
- 3
Installation of the drive is fairly simple. The optical or hard drive is set to be a single master drive configuration and the cabled plugged into the IDE, power and audio connectors. The audio connector is a simple flat plug instead of an MPC-2 standard connector which is a bit of a problem as the cable could be put in backwards. The drive is then screwed down into the bottom tray through the holes on the bottom of the tray that match the drive. The top cover is put in place and the two side panels are installed to hold the top panel down. The optional front bezel is put in place if a hard drive is installed inside of the case. That's it for the installation of the enclosure.
